SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series SiBE18-821_C
318 Operation Manual
English 10
PROGRAMMING TIME
TIMER RESERVE
Press the TIMER RESERVE button.
TIMER CANCEL
For example.
1
2
3
4
NOTES
îš„ For Heat pump system
Outdoor unit
Indoor unit
TIMER MODE START/
STOP
Press the TIMER MODE START/STOP
button several times and select the
mode on the display.
Press the PROGRAMMING TIME
button and set the time for stopping
or starting the system.
When this button is pressed, the
time advances by 1 hour.
When this button is pressed, the
time goes backward by 1 hour.
Press the TIMER OFF button to cancel
programming. The display vanishes.
When the timer is
programmed to stop
the system after 3
hours and start the
system after 4
hours, the system
will stop after 3
hours and then 1
hour later the
system will start.
•
When the timer is programmed to stop
the system after 3 hours and start the
system after 4 hours, the system will
stop after 3 hours and then 1 hour later
the system will start.
•
After the timer is programmed, the
display shows the remaining time.
HOW TO SET MASTER
REMOTE CONTROLLER
(For VRV system)
•
When the system is installed as
shown below, it is necessary to
designate the master remote
controller.
When one outdoor unit is connected with
several indoor units.
One of these remote controllers needs
to be designated as the master remote
controller.
The display flashes.
For setting the timer stop ....
For setting the timer start ....
The timer setting procedure ends.
The display or changes from flashing
light to a constant light.
To Next Page
Loading...
Need help?
General
