Field Wiring Si39-303
188 Installation Manual
Caution For low-noise operation, it is necessary to get the optional “External control adaptor for outdoor
unit”.
For details, see the installation manual attached to the adaptor.
Picking power line and transmission line
!
Be sure to let the power line and the transmission line pass through a conduit hole.
!
Pick the power line from the upper hole on the left side plate, from the front position of the
main unit (through the conduit hole of the wiring mounting plate - optional parts) or from a
knock out hole to be made in the unit’s bottom plate.
2
4
5
6
7
6
8
10
9
3
1. Electric wiring diagram printed on the back of the
electric box lid
2. Section A
3. Knockout hole
4. Power wiring between outdoor units
(When the wiring is routed out through the front
panel.)
5. Power wiring between outdoor units
6. Set apart
7. Power wiring between outdoor units
(When the wiring is routed out through the lateral
panel.)
8. Electric wiring
9. Through cover
10.Cut off the shaded zones before use.
lectric wiring diagram printed on the back of the electric box lid
[ 1 ]
To Next Page
Loading...
