FIRST USE OF MATILDA®
NEVER START A CYCLE UNLESS THE UNIT HAS FILLED WITH WATER. FAILURE TO DO SO WILL RESULT
IN DAMAGE TO THE UNIT AND VOID THE WARRANTY.
BEFORE USING THIS UNIT FOR THE FIRST TIME, WASH OUT THE INSIDE OF THE SINK WITH HOT SOAPY WATER
AND RINSE CLEAN. INITIAL CLEANING OF THE SINK IS NECESSARY TO REMOVE DIRT AND CONTAMINATION
FROM TRANSIT. SEE CLEANING INSTRUCTIONS ON PAGE 8.
Matilda® Set-Up Menu
Step 1. Plug in the unit to the power source
Step 2. Connect the water and turn water on. Also connect the drain tube and direct it to the floor
drain.
Step 3. Now, turn on rear power switch. Matilda® should immediately begin to fill with water.
Once she has filled to the level of the float switch, she will begin heating the water bath to the preset
maintenance temperature (IDLE TEMP).
Power Switch
Cold Water
Connection
Drain Tube
External Circuit
Breaker
Power Cord
You are now ready to make adjustments to Matilda’s Settings.
To Next Page
Loading...
