To Next Page
C
Charles BlackOct 29, 2025
Why is my Dake SE-712 Saw blade breaking so much?
- EElizabeth HayesOct 29, 2025
Excessive blade breakage in your Dake Saw can occur due to several reasons: * The material may be loose in the vise - ensure you clamp the work securely. * The speed or feed might be incorrect - adjust the speed or feed accordingly. * The blade teeth spacing could be too large - replace it with a blade that has smaller teeth spacing. * If the material is too coarse, use a blade with slow speed and small teeth spacing. * Incorrect blade tension can also cause this issue - adjust it so the blade doesn't slip on the wheel. * Ensure the teeth are not in contact with the material before starting the saw; place the blade after the motor is started. * If the blade rubs on the wheel flange, adjust the wheel alignment. * Misaligned guide bearings should be adjusted. * A blade tha...
General
