Dalsa Spyder2 S2-2x-04K40 User Manual

69 Spyder2 4k User’s Manual
03-032-10195-04 DALSA
Cod
e
Command Short
Form
Parameters Description
19 region_of_interest
roi i i
Set the pixel range for reading
end-of-line statistic and for the
region of pixels used in the
cag, cao, gl, gla, ccf, and
ccp commands. Pixel start and
end values in a range from 1 to
sensor pixel count.
20 reset_camera
rc
Reset the entire camera
(reboot).
21 reset_pixel_coeffs
rpc
Reset the pixel coefficients to
0.
22 restore_factory_settings
rfs
Restore the camera’s factory
settings. FPN and PRNU
coefficients reset to 0.
23 restore_user_settings
rus
Restore the camera's last saved
user settings and FPN and
PRNU coefficients.
24 set_add_background
sab t i
Adds the background value to
the camera output. The first
parameter is the tap selection 1
to 2, or 0 for all taps. The
second parameter is the add
offset value range from 0 to
1023.
25 set_analog_offset
sao t i
Set the analog offset. The first
parameter is the tap selection 1
to 2, 0 for all taps. The second
parameter controls the digital
analog converter (DAC), in a
range from 0 to 1023 that sets
analog offset. Offset increases
with higher values.
26 set_baud_rate
sbr i
Set speed of serial
communication port. Baud
rates: 9600, 19200, 57600, and
115200. Default baud: 9600
27 set_camera_id
sci s [s]
Set camera ID. The first
parameter is a character A to
Z, or 0 to 9. The second
optional parameter is the serial
number of the addressed
camera.
28 set_data_mode
sdm i
Set the data mode of camera
output to:
0: 8 bit, A/B/C/D ports, single
processor
1: 10 bit, A/B/C and D/E/F
ports, single processor
Parameters:
i = integer
f = float
t = tap selector
s = string
x1 = pixel start
number
x2= pixel end number
[]= optional
parameter

Dalsa Spyder2 S2-2x-04K40 Specifications

General

Brand	Dalsa
Model	Spyder2 S2-2x-04K40
Category	Security Camera
Language	English