What to do if Dalsa Security Camera shows no output or erratic behavior?
If your Dalsa Security Camera is showing no output or behaving erratically, it might be picking up random noise because of long cables acting as antennas. Verify that the camera is not receiving spurious inputs, for example, EXSYNC if the camera is in exposure mode that requires external signals.
What to do if Dalsa Security Camera has line dropout, bright lines, or incorrect line rate?
If your Dalsa Security Camera is experiencing line dropout, bright lines, or an incorrect line rate, verify that the frequency of the internal sync is set correctly. If the camera is set to external sync, ensure that the EXSYNC signal supplied to the camera does not exceed the camera’s usable line rate under the current operating conditions.
General| Brand | Dalsa |
|---|---|
| Model | Spyder3 SG-11-01k40-00-R |
| Category | Security Camera |
| Language | English |
Key features and programmability of the DALSA Spyder3 GigE Vision camera.
Detailed technical specifications for camera resolution, pixel size, speed, and sensitivity.
Information regarding the camera's dual line scan sensor technology and modes.
Graphs illustrating spectral responsivity for 1k/2k and 4k models.
Mechanical dimensions, mounting options, and interface connectors for the camera.
Recommendations for mounting the camera and guidance on illumination.
Details on electrical interface standards and EMC compliance requirements.
Step-by-step guide for installing the camera, software, and drivers.
Minimum PC, network adapter, and switch requirements for optimal performance.
Information on available drivers and their installation procedures.
Details on Ethernet, Power, and GPIO connectors and their pin assignments.
Explanation of the diagnostic LED colors and their meanings for camera status.
Using GenICam for camera control, including interface and command details.
Default factory settings and initial configuration upon first power-up.
Configuration of sensitivity mode and CCD shift direction for image output.
Details on exposure modes, line rates, and synchronization timing parameters.
Setting up GPIO pins for input and output signals for camera control.
Explanation of analog and digital signal processing chains within the camera.
Procedure for removing image non-uniformity using FPN and PRNU correction.
Explanation of flat field correction process and its benefits.
Guidelines and limitations for accurate flat field correction results.
Understanding calibration results and error reporting mechanisms.
Procedures for saving and restoring factory and user settings and coefficients.
How to restore the camera to its original factory default settings.
Methods for saving and restoring custom user settings and coefficients.
Tools for diagnosing camera issues, including test patterns and measurements.
How to generate test patterns for verifying camera functionality and connections.
Procedure for checking the camera's internal temperature.
Procedure for checking the camera's input voltage.
Understanding warning and error messages and their causes.
List of common warning and error messages and their potential causes.
Methods for minimizing dark current artifacts using readout modes.
Steps to solve common problems during camera setup and operation.
Solutions for common issues like no output, line dropout, and dark patches.
To Next Page
