Dalsa Spyder3 SG-11-01k40-00-R - Configuring the GPIO Connector

Spyder3 GigE Vision User’s Manual
DALSA 03-032-20027-02
43
5.6 Configuring the GPIO Connector
The following commands provide a connection between the GPIO controller and the
camera’s internal functions.
Setting the GPIO Output Signal
Sets the signal type for the selected output.
GPIOSelector
Output to set.
Port0 = Output 0, pin 11 (TTL) or 11 and 12 (LVDS)
Port1 = Output 1, pin 13 (TTL) or 13 and 14 (LVDS)
Port2 = Output 2, pin 15 (TTL) or 15 and 10 (LVDS)
Port3 = Output 3, pin 9 (TTL)
GPIOOutput
Signal type.
0 = Disable
1 = TTL
2 = LVDS
Related Commands: GPIOInput
Setting the GPIO Input Signal
Sets the signal type for the selected input.
GPIOSelector
Input to set.
Port0 = Input 0, Pin 1 (TTL) or 1 and 2 (LVDS)
Port1 = Input 1, Pin 3 (TTL) or 3 and 4 (LVDS)
Port2 = Input 2, Pin 6 (TTL) or 6 and 7 (LVDS)
Port3 = Input 3, Pin 8 (TTL)
GPIOInput
Signal type.
0 = Disabled
1 = TTL
2 = LVDS
Related Commands: GPIOSelector