2.1. Rigging components
Q-Series arrays suspended by the Z5159 Q Flying frame are assembled
using the following rigging components:
2.1.1. Z5159QFlyingframe
Fig. 2: Z5159 Q Flying frame
The Z5159 Q Flying frame is designed to support arrays consisting of the
following loudspeakers:
Code Type Weight incl. array links
Z0510 Q-SUB 42 kg (93 lb)
Z0501 Q1 23 kg (51 lb)
Z0507 Q7 23 kg (51 lb)
Z0511 Q10 23 kg (51 lb)
The weight of the Q Flying frame is 13 kg (29 lb)
80 [3.2"]
4 [0.16"]
12.5 [0.5"]
7 [0.3"]
603 [23.7"]
589 [23.2"]
685 [27"]
Fig. 3: Z5159 Q Flying frame dimensions in mm [inch]
2.1.2. Z5155QHoistconnectorchain
Fig. 4: Z5155 Q Hoist connector chain
The Z5155 Q Hoist connector chain is used to connect the lifting motor(s)
to the Q Flying frame using one or two 1t Shackles supplied with the
connector chain. Its length of 52 cm (20.5“) allows enough space for the
hang of most 1t motor chain containers.
2.1.3. Z5154QRiggingset
a) b) c )
Fig. 5: Z5154 Q Rigging set
One set is required for each Q-Series cabinet within a vertical array. The
rigging set includes the following components:
2 x Z5151 Q Splay link [a]
2 x Z5152 Q Front link [b]
8 x Z5153 Locking pins 8 mm (linked in pairs with a steel wire) [c]
Q-Series Rigging manual (1.2EN) Page 6 of 20
To Next Page
Loading...
