A I R E N C E - U S B M a n u a l P a g e 6
CUE/COMMUNICATION BUSS
signal before you raise your channel fader up and mix it with other signals in the mixer.
communicaon. If you push a DJ’s Cue (let’s
say channel one) and if you then push the Telco Cue, the DJ as well as the caller can hear each other out-
Levels need to be carefully set to avoid feedback and overdrive of circuits.
ON
FADER
-
ed fader start switch. At the beginning of the fader movement you will feel an integrated start switch that
knob), the control room level (or Studio level) will be dimmed by 20dB when in the input module Mic is
-
to your needs.
To Next Page
Loading...