D&R AIRENCE - Firmware Flashing Process; Preparation for Firmware Update; Flashing Firmware into Device

A I R E N C E - U S B M a n u a l P a g e 61
Firmware Update Procedure
Preparation

- Connect a USB cable between the Airence mixer and the PC
- Startup the Airence mixer in bootloader mode
- www.d-r.nl (e.g. airence_rmware_v1_4.zip)
Flash firmware into device
- Startup the Airence Firmware Updatetool
- 
- 

-

Get version info-
sion info if the device is NOT in bootloader mode.