Danfoss 103E5 Installation And User Guide

14
Setting the time & the programme
Before you start
 Open the  ap on the front of
the unit.
 Press all four buttons
(SELECT / ADVANCE / + / -)
at the same time
This will reset the unit, reinstate the
preset programmes and set the time to
12:00pm on Monday.
Setting the clock
 Press PROGRAMME once
 Use + and – buttons to set the
correct time
 When time is correct press
PROGRAMME again.
In 24 hour mode this will take you
straight to programming mode,
where you can select your own ON
and OFF times.
PROGRAMME
+
-
PROGRAMME
+
-
PROGRAMME
+
-
In 5/2 day mode this will  rst allow you to programme the
correct DAY. To do this:
 use the + or – buttons to select the correct day
 press PROGRAMME again to enter RUN mode

Danfoss 103E5 Specifications

General

Brand	Danfoss
Model	103E5
Category	Thermostat
Language	English