138 Capacity controller RS8HE202 © Danfoss 2017-07 AK-PC 781A
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alternations can be made without subsequential changes being necessary in specifications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
Installation considerations
Accidental damage, poor installation, or site conditions, can give rise
to malfunctions of the control system, and ultimately lead to a plant
breakdown.
Every possible safeguard is incorporated into our products to prevent
this. However, a wrong installation, for example, could still present
problems. Electronic controls are no substitute for normal, good
engineering practice.
Danfoss will not be responsible for any goods, or plant components,
damaged as a result of the above defects. It is the installer's respon-
sibility to check the installation thoroughly, and to fit the necessary
safety devices.
Special reference is made to the necessity of signals to the controller
when the compressor is stopped and to the need of liquid receivers
before the compressors.
Your local Danfoss agent will be pleased to assist with further advice,
etc.
ADAP-KOOL®
To Previous Page
Loading...
Need help?
General
