AKD 2800
Programming
Description of choice:
Key in a % value.
137 DC hold voltage
(DCHOLDVOLTAGE)
Value:
0 - 100% of max. DC hold voltage
✭ 0%
Function:
This parameter is used to keep the motor
(holding torque) at start/stop.
Description of choice:
This parameter can only be used if a selection has
been made of DC hold in parameter 121 Start
function or 122 Function at stop . To be set as
a percentage value of the max. DC hold voltage,
which depends on the choice of motor.
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.28.H2.02 -
23
To Next Page
Loading...
