What to do if output LED(s), alarm LED and output menu LED flash and buzzer is ON on Danfoss Controller?
If the output LED(s), alarm LED, and output menu LED are flashing and the buzzer is on, it indicates that the output or actuator is short-circuited, or the actuator is disconnected. Check for short circuits or disconnection of the actuator.
What to do if output LEDs 1-4, alarm LED and input LED flash on Danfoss CF-MC Controller?
If output LEDs 1-4, the alarm LED, and the input LED are flashing, it means there is no signal from the CF-RC Remote Controller. Check the CF-RC Remote Controller for functionality.
What to do if output LED(s), alarm LED and input menu LED flash and buzzer is ON after 12 hours on Danfoss Controller?
If the output LED(s), alarm LED, and input menu LED flash and the buzzer is on after 12 hours, it indicates that there is no wireless signal from the room thermostat connected to these outputs or the temperature in the according room is below 5 °C. Try to verify the function of the room thermostat by making a link test.
What to do if Danfoss CF-MC Controller shows E03 and *?
If the controller displays 'E03 and *,' it indicates an actuator error on the output (CF-MC). Check for errors in the actuator on the output.
What does it mean when the LED ( and *) flashes every 30 sec on Danfoss CF-MC?
If the LED ( and *) flashes every 30 seconds, it indicates a critically low battery. Replace the battery immediately.
Why are CF-MC Master controller 1 Alarm and Install LED’s flashing and CF-MC Master Controller 2 Alarm LED lighting up on Danfoss Controller?
This issue occurs because CF-MC Master Controller 2 has an older version of the software that is not compatible with the newer software in CF-MC Master Controller 1. Update the software of CF-MC Master Controller 2 to be compatible with CF-MC Master Controller 1.
What to do if output LEDs 1-5, alarm LED and input menu LED flash on Danfoss CF-MC?
If output LEDs 1-5, the alarm LED, and the input menu LED are flashing, it means there is no signal from CF-MC Master Controller 2 or 3. Check the connection or functionality of CF-MC Master Controller 2 or 3.
What does it mean when the LED ( and *) flashes every 5th minute on Danfoss Controller?
If the LED ( and *) flashes every 5th minute, it indicates a low battery. Replace the battery.
What to do if Danfoss CF-MC shows E05 and *?
If the controller displays 'E05 and *,' it indicates that the room temperature is below 5 °C. Increase the room temperature above 5 °C.
What does it mean when the LED,, and flashes* on Danfoss CF-MC?
If the LED, , and flashes*, it indicates a critically low battery, and transmission has stopped. Replace the battery to restore transmission.
Explains the conditions and scenarios that require resetting the Master Controller in a CF2-system.
Provides step-by-step instructions for performing a factory reset on the Master Controller CF-MC.
Outlines the procedure for resetting CF-RS, -RP, -RD, and -RF Room Thermostats.
Describes the process for resetting the CF-RC Remote Controller.
Provides instructions for resetting the CF-RU Repeater Unit.
General| Brand | Danfoss |
|---|---|
| Model | CF-MC |
| Input Frequency | 50/60 Hz |
| Enclosure Rating | IP20 |
| Mounting | Wall mounting |
| Power Supply | AC |
| Protection Features | Short circuit |
| Operating Temperature | +50°C |
| Relative Humidity | 5 to 95% RH, non-condensing |
| Cooling Method | Convection cooling |
To Next Page
