Danfoss ECtemp™ Smart
11Installation Guide
the female header, in not to bending the connectors.
Press carefully until the frame is xed against the
rubber gasket.
When mounting and reassembling the thermostat.
Important: Do NOT press in the center of the display screen.
Press your ngers under the side of the front part and pull
toward you until it releases from the snap lock:
To ensure that the batteries are fully charged, the ther-
mostat shall be connected to main supply for minimum
15 hours. The current time and day is kept for 24 hours if
mains supply is o.
All other settings are stored permanently.
To Next Page
Loading...
Need help?
General
