Danfoss ECtemp Smart - Settings

Danfoss ECtemp™ Smart
19Installation Guide
7 Settings
IMPORTANT DURING SET-UP
Select whether only a oor sensor
or a combination of room and oor
sensor should be used.
A “room only” option is also avail-
able, but requires that you have to
break the small plastic seal on the
back of the display module, e.g. us-
ing a screwdriver; it will be possible
to set the maximum oor tempera-
ture up to 45°. Furthermore, it will be
possible to use only a room sensor.
However, this option is not recom-
mendable due to an increased risk
of overheating the oor.