Danfoss ECtemp Touch

Danfoss ECtemp Touch
11Installation Guide
5. If you have already made
the installation setup online,
press ENTER CODE and go
directly to Step 13 now. Oth-
erwise press SETUP WIZARD
and go to Step 6.
6. On the SETUP information
screen, press to start.
7. Use the < and > arrows to
select whether only a oor
sensor or a combination of
room and oor sensors
should be used. Press to
conrm.
Note: A “room only” option may also be available. For details, see
the “Maximum Floor Temperature” section.