Software for PC
USB gateway
USB programming key
Docking station
Software tool
Software from Danfoss for programming the
ERC 112 via a USB gateway and a PC rather than
with the front panel buttons.
USB gateway
The USB Gateway is a laboratory tool, offering
fast and easy programming of any ERC
controller connected directly to the PC.
"Software tool" installation kit is provided for the
PC. The gateway is standard inventory for OEM
labs.
Programming an individual unit in a
laboratory
The USB key requires "Software tool" running on
a PC. It enables parameters to be set in real time
and an array of status information to be read
(bidirectional connection).
Once the desired settings have been
determined, a specific parameter file is saved to
the USB key for later mass programming through
the docking station.
Mass programming on an assembly line:
The docking station is used for high volume
programming of ERC controllers, for example on
an assembly line. The docking station is a
write-only device.
The USB key, is to be inserted into the docking
station. The settings are then loaded into each
successive controller in a matter of seconds.
"Software tool" is not required for mass
programming.
Quick programming
To Next Page
Loading...
