Why won't the compressor start on my Danfoss ERC 112D VSC Controller?
If the compressor on your Danfoss Controller isn't starting, it could be due to a faulty frequency table. You should check the frequency cable continuity and the connection of the frequency cable at both the controller and drive side.
What to do if the Danfoss ERC 112D VSC display alternates between high and temperature?
If the display on your Danfoss Controller alternates between 'high' and the temperature, it indicates that the temperature is too high. Check ALA->HAt to resolve this issue.
Why does the Danfoss ERC 112D VSC Controller display alternate between low and temperature?
If your Danfoss Controller display alternates between 'low' and the temperature, this means the temperature is too low. To fix this, check ALA -> LAt.
What causes the Danfoss ERC 112D VSC Controller display to alternate between condenser and temperature?
If the display on your Danfoss Controller alternates between showing the condenser status and the temperature, it means the condenser is too hot. Clean the condenser and check Con ->CAL, CbL.
What to do if the fan does not start in Danfoss ERC 112D VSC?
If the fan on your Danfoss Controller isn't starting, it might be because the door is open or the door contact is defective. Check that the door contact is okay.
Why doesn't the Danfoss Controller shift between ECO and normal mode on ambient light change?
If your Danfoss Controller isn't shifting between ECO and normal mode when the ambient light changes, it could be because the ambient light sensor is broken or the light level isn't set properly. Check Eng->SLd, SLn.
What to do if the alarm does not sound on Danfoss ERC 112D VSC?
If the alarm on your Danfoss Controller isn't sounding, it could be because the alarm is delayed. Check ALA->Htd, Abd and Pud->Pdd.
What to do if defrost does not start on Danfoss Controller?
If defrost isn't starting on your Danfoss Controller, it might be because the controller is in pull-down mode. Check parameter Pud->Pdi.
How to fix weak display brightness on Danfoss ERC 112D VSC?
If the display brightness on your Danfoss Controller is weak, the ambient light sensor might be broken. Replace the sensor.
What does "dEf" mean on my Danfoss Controller display?
If your Danfoss Controller display shows 'dEf', it indicates that a defrost is in progress. Check diS ->SdF.
Setting temperature, acknowledging alarms, and changing parameters.
Parameters for set point, differential, and temperature limits.
Settings for defrost type, termination temperature, and reset.
Configuration for minimum/maximum defrost intervals and duration.
Settings for minimum, maximum, start, and defrost speeds.
Configuration for PI controller gains and frequency settings.
Settings for enabling ECO mode via door actions or PIR.
Defining sensor types and applications for inputs.
Assigning functions to controller buttons via short and long presses.
Setting and managing password levels for access control.
Common issues, probable causes, and recommended remedies.
Reference for alarm codes, triggers, and automatic clearance.
General| Brand | Danfoss |
|---|---|
| Model | ERC 112D VSC |
| Category | Controller |
| Language | English |
To Next Page
