4| Installations
4.1| Dimensions (mm)
83
66
Rear mounting (lock with clips)
Drilling template61.2
28
36
71
29
4.2| Mounting
Mounting Unmounting
4.3| Installation steps
– Place the wired controller in the slot and ensure rubber sealing is resting properly on the mounting surface.
– Slide the mounting clips along the rails of the rear plastic from the rear side of the panel.
– Slide the clips towards mounting surface until controller is firmly fixed.
– To remove the controller, one needs to skillfully unlatch the snapping tab and pull the clips backwards.
To Next Page
Loading...
