Danfoss FC 300 Series User Manual

3.6.4 4-6* Speed Bypass
Some systems call for avoiding certain output frequencies or
speeds due to resonance problems in the system. A
maximum of four frequency or speed ranges can be avoided.
4-60 Bypass Speed From [RPM]
Array [4]
Range: Function:
Application
dependent
*
[Application
dependant]
Some systems call for
avoiding certain output
speeds due to resonance
problems in the system.
Enter the lower limits of the
speeds to be avoided.
4-61 Bypass Speed From [Hz]
Array [4]
Range: Function:
Application
dependent
*
[Application
dependant]
Some systems call for
avoiding certain output
speeds due to resonance
problems in the system.
Enter the lower limits of the
speeds to be avoided.
4-62 Bypass Speed to [RPM]
Array [4]
Range: Function:
Application
dependent
*
[Application
dependant]
Some systems call for
avoiding certain output
speeds due to resonance
problems in the system.
Enter the upper limits of the
speeds to be avoided.
4-63 Bypass Speed To [Hz]
Array [4]
Range: Function:
Application
dependent
*
[Application
dependant]
Some systems call for
avoiding certain output
speeds due to resonance
problems in the system.
Enter the upper limits of the
speeds to be avoided.
Parameter Descriptions FC 300 Programming Guide
MG.33.MA.22 - VLT
®
is a registered Danfoss trademark 3-47
3
3

Danfoss FC 300 Series Specifications

General

Category	DC Drives
Enclosure	IP20
Communication Options	CANopen
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Input Voltage	380-500V AC