Danfoss FC 300 Series

3.19 Parameters: 18-** Data Readouts 2
18-36 Analog Input X48/2 [mA]
Range: Function:
0.000 * [-20.000 - 20.000 ] View the actual current measured at
input X48/2.
18-37 Temp. Input X48/4
Range: Function:
0 * [-500 - 500 ] View the actual temperature measured at input
X48/4. The temperature unit is based on the
selection in par. 35-00.
18-38 Temp. Input X48/7
Range: Function:
0 * [-500 - 500 ] View the actual temperature measured at input
X48/7. The temperature unit is based on the
selection in par. 35-02.
18-39 Temp. Input X48/10
Range: Function:
0 * [-500 - 500 ] View the actual temperature measured at input
X48/10. The temperature unit is based on the
selection in par. 35-04.
18-60 Digital Input 2
Range: Function:
0 * [0 - 65535 ] View the signal states from the active digital
inputs. '0' = no signal, '1' = connected signal.
18-90 Process PID Error
Range: Function:
0.0 % * [-200.0 - 200.0 %]
18-91 Process PID Output
Range: Function:
0.0 % * [-200.0 - 200.0 %]
18-92 Process PID Clamped Output
Range: Function:
0.0 % * [-200.0 - 200.0 %]
18-93 Process PID Gain Scaled Output
Range: Function:
0.0 % * [-200.0 - 200.0 %]
Parameter Descriptions FC 300 Programming Guide
3-140 MG.33.MA.22 - VLT
®
is a registered Danfoss trademark
3
3