Danfoss NovoCon Series User Manual

© Danfoss | 2017.05
VI.HU.I3.02 | 1
NovoCon® S CO6, Energy, I/O - High Accuracy Actuator
Operating Guide
❶
IP40
IP54
IP54
IP54
❷ ❸
❹
❺
①
②
❻
Calibration:
Press button ① until two
LED’s are turned on
DIP switch: ②
Manual override:
Adjust wheel ③
❼
NovoCon® analog cable
*VIHUI302*
③
②
①
Common ground shall be
used for all devices on the
same network.
Digital port
Port for CO6 actuator or Energy cable, I/O cable,
analog cable or voltage booster.
Digital port
Actuator NovoCon® ChangeOver
6
Flexible
NovoCon® Energy cable
- PT1000 surface sensors
NovoCon® Energy cable
- PT1000 immersed sensors
NovoCon® I/O cable
Red Power 24V
Black GND
Grey Analog input
Blue Analog input ground
NovoCon® digital cable
Red Power
Black
Green ´+´ non-inverting signal wire
White/green ´−´ inverting signal wire
Common ground for power
and bus signal wire
Purple O-ring
Actuator NovoCon®
ChangeOver
6
Red Power 24V
Black GND
White CO6 Control signal
Grey CO6 Feedback signal
Blue O-ring
Actuator NovoCon®
ChangeOver
6
Energy
Red Power 24V
Black Power ground. T1, T2 and V output signal ground.
Blue V/mA input signal ground
Grey V/mA input signal
White V output signal
Yellow T1 or resistance input
Orange T2 or resistance input

Danfoss NovoCon Series Specifications

General

Brand	Danfoss
Model	NovoCon Series
Category	Controller
Language	English