4. Place washers 8x (80) on screws 8x (81).
a) Place the 2 screws with washers in end cover (66), see Exploded view on page 6.
Make sure that all O-rings stay in place. The two screws must screw in with fingers only, so that
the end cover stays in parallel with flange area of the housing only, with distance for
compressing the O-rings less than 1 mm.
b)
Screw in screw (83) with washer (82) using a 10 mm Hex key until end cover is in place.
Service Manual
OSQA/OSQB
Assembly
36 |
©
Danfoss | July 2016 HN25D293 | AX00000127en-US0101
To Next Page
Loading...