E
emily69Aug 9, 2025
What to do if Danfoss Controller has no actuation?
- OorozcotaylorAug 9, 2025
If your Danfoss Controller isn't actuating with either AUX-steering or auto-guidance, here are a few things to check: * First, make sure the valve is getting enough pressure. * Next, verify that the Auto-guidance controller or AUX-steering device is properly mapped. * Also, check if the flow/angle limited parameters are set too low and adjust them if needed. * Confirm that the correct auto-steering message is being sent from the external set-point controller. * Finally, ensure the system isn't in road mode; if it is, switch it to the appropriate mode.