Danfoss PVED-CLS - Page 38

PVED-CLS auto calibration— spool dead-band
If the parameter change is not described below, use the default values.
Spool Dead-band Calibration values set the behavior of the Auto Spool Calibration routine which finds
the Closed Loop dead-band edges for the spool calibration.
See Section 9.4.1.1 in the User Manual for more detailed descriptions of the parameters.
Example parameter settings
Application Guide
PVED-CLS startup guide
Parameter setting
38 |
©
Danfoss | October 2018 AB285975085591en-000101