18 | VUIGI102 © Danfoss | 2018.01
5. Meter access and
configuration
(continuous)
Input-output channels, set archive date and tariffs configuration
Pulse channel is configured by tagging:
- type (input or output);
- source (heating or cooling);
- energy;
- medium volume;
- external signal (L1, L2).
Decimal place in the display and pulse value must be configured too (only for inputs). Press Read and
then Write to enable write configuration to device.
Archive writing time can be configured by writing SetDay time and date and Archive month day.
Tariff thresholds can be configured by writing Threshold value and by selecting Trigger and
Counter op tions. Tag Tariff ½ enable to enable Tariffs. Thresholds levels are shown in pictures as
lines. Different types of thresholds can be selected in Tariff type sections.
Also tariff type can be time interval. Counter will work in time interval from trigger 2 to trigger 1, or
from trigger 1 to trigger 2, or counter 1 and counter 2 can work sequentially.
Press Write to load configuration into device. If device is successfully configured the message Device
Ready will pop up.
These parameters can be changed only in test mode.
Fig. 5.10 Configuration window, Time Trigger
Configuration window parameters
No. Name Note
1 Pulse channel 1 / Pulse channel 2 Field for channel 1 and channel 2 configuration
2 Input / Output Purpose of pulse channel
3 Input/output source
4 Heating energy Only available for output channel
5 Cooling energy Only available for output channel
6 Medium volume
7 L1 / L2 Pulse signal source for tariff 1 (L1), tariff 2 (L2)
8 VIF Decimal place in the display
9 Pulse value m
3
/impulse
10 Archive
11 Setday Year month and day Device will archive information of 1 year duration measurements
12 Archive month day Device will archive information of 1 month duration measurements
13 Tariff thresholds
14 Tariff ½ enable Tag to allow tariffs
15 Threshold 1 / Threshold 2 Levels of selected trigger.
To Next Page
Loading...
Need help?
General
