Danfoss TP7000 Installation Instructions & User Guide

11
c) When all 6 events are correct, press
DAY to programme events for Day 2.
(If you wish to repeat the previous
day’s programme, simply press
COPY).
d) Repeat steps b & c above to
programme (or COPY) events for Days
3, 4, 5, 6 & 7.
Returning to RUN Mode – press PROG
until colon  ashes in display.
 Press PROG until Event 1  ashes, then
press DAY until display shows Day 1-
5.
 Follow steps b & c on page 10-11 to
programme times & temperatures for
weekdays.
 Press DAY to programme events for
weekend (Day 6-7) or press COPY to
repeat weekday programme.
Returning to RUN Mode – press PROG
until colon  ashes in display.
Programming in 5/2 day mode
(one set of programmes for weekdays, another set for weekends)
1 2 3 4 5
User Instructions
GB

Danfoss TP7000 Specifications

General

Type	Programmable Room Thermostat
Display	LCD
Frost Protection	Yes
Holiday Mode	Yes
Voltage	230V AC
Accuracy	±0.5°C
Programming	7-day programmable
Mounting	Wall-mounted
Contact Rating	3A (resistive)
Switching Current	3A (resistive)
Communication	Not applicable