Danfoss TP7000 Installation Instructions & User Guide

10
The unit is now in RUN mode (colon  ashes in
display) and the heating will operate according
to the preset programmes.
a) Press PROG until Event 1  ashes, then press
DAY to move from current day to Day 1.
b) Amend the time and temperature as
follows:
i) Use + and – buttons to alter time
(press and hold to change in 10 min
increments).
ii) Use  and  buttons to alter
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to next Event.
iv) Repeat steps i,ii & iii above for Events 2,
3, 4, 5 & 6.
Programming in 7-day mode
(separate programmes for each day of the week)
1
Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day mode
or 5/2 day mode. To tell which mode your unit is set press PROG until
Event 1  ashes in the display.
This unit is in 7-day mode and you can programme
di erent settings for each day of the week (see page 10-
11).
This unit is in 5/2 day mode and you can enter one of
set of programmes for weekdays and another set for
weekends (see page 11).
1
1 2 3 4 5
User Instructions
GB

Danfoss TP7000 Specifications

General

Type	Programmable Room Thermostat
Display	LCD
Frost Protection	Yes
Holiday Mode	Yes
Voltage	230V AC
Accuracy	±0.5°C
Programming	7-day programmable
Mounting	Wall-mounted
Contact Rating	3A (resistive)
Switching Current	3A (resistive)
Communication	Not applicable