9
Display preferences
Temperature display (°C or °F)
Press and hold DAY & COPY (for 2-3 seconds)
until display changes.
Clock display (12 or 24 hr)
Press and hold NEXT & DAY (for 2-3 seconds)
until display change.
(AM or PM will appear in 12 hr mode)
Setting the Clock & Day
Press PROG to begin programming.
DAY - Press DAY until correct day is shown
(1=Monday, 2=Tuesday etc).
TIME - Press + and - to change time (press and
hold to change in 10 min increments).
This display will ONLY appear if the OSC function has
been enabled by your installer.
Use the + or - buttons to select the OSC
period. The choices are 0:30 (30 mins), 1:00 (1
hr), 1:30 and 2:00.
The recommended setting is 0:30. If set to
0:00 the function is disabled.
To change DAY
To change TIME
Setting the OSC Period, if enabled (see pg.5)
Accepting the preset programmes
If you are happy to use the preset programmes on page 8, you don’t
need to do anything else. To accept these settings just close the
front cover and after 2 minutes the pre-settings will automatically be
accepted.
User Instructions
GB
To Next Page
Loading...
Need help?
General
