17
Before you start
Resetting the unit
Open the fl ap on the front of your
programmer.
Press and hold the four buttons , , -
and + simultaneously for 3 seconds until
the display goes blank, then release the
buttons.
This will reinstate the preset programmes
and will set the time to 12:00 on Day 1.
Setting the Clock
Press PROG until the time and day number
begin to blink in the display.
TIME - Press + and - to change time (press
and hold to change in 10 min increments).
Press PROG again.
First time installation only
When the unit is fi rst removed from its packaging the display will,
most probably, just show two dots (the colon). This is not a fault,
but a battery saving feature.
Once fi tted in accordance with the Installation Instructions
supplied and the mains electricity is switched on, the unit should
be activated by pressing any button and then RESET.
User Instructions
GB
To Next Page
Loading...
