24
Running your programme
The TP9 will control your Central Heating and Domestic Hot Water
system in any one of three ways.
To switch between the 3 operating modes press both the and
buttons simultaneously. The display will alter as shown.
1. Heating & Hot Water
Automatically controls room
temperature as programmed and
switches on hot water twice a day.
2. Heating only
Provides a constant low room
temperature while the home is empty
for extended periods.
(N.B. When the unit switches the CH on,
the HW will also switch on if the unit has
been set for linked GRAVITY operation).
3. Water only
Switches Hot Water on and off twice a
day during the summer, or other times
when Central Heating is not needed.
However, if the room temperature falls
below the low setting displayed, the
heating will switch ON.
NOTE: If the minimum temperature has been set to 16°C and you
do not want the heating to switch ON at all whilst operating in this
mode, you should ask your installer to fi t an extra switch to the CH
output. He can get the information he needs to do this from our
Technical Services Department.
User Instructions
GB
To Next Page
Loading...
