7
Wiring
On the following pages are typical wiring diagrams for various
types of systems.
Whilst every attempt has been made to ensure the accuracy
of this information it is recommended that the specifi c
information relating to the ancillary controls is obtained from
the manufacturers concerned.
NOTE:
The TP9 does not have voltage free contacts, therefore it is
NOT suitable for connection to extra low voltage equipment
(i.e. > 50 Volts).
Remote Sensor to be wired with 1mm 2 core double insulated
cable only. Cable length should not exceed 50 metres. Sensor
cable should NOT be run parallel to mains cable.
Wiring
GB
To Next Page
Loading...
