Danfoss VLT 5072 - Page 48

VLT® 5000 Crane
Programming
PNU Parameter Range Factory setting Changes Unit Conversion Data Protection
#
4xx
description
Application functions
during
operation
index index type level
400 Brake function/over-
voltage control
Resistor Yes 0 0 5 1
401 Brake resistor, ohm 0 - 500 Depends on unit Yes 23 -1 6 1
402 Brake power limit, kW 0 - 1000kW 0 kW Yes 9 2 6 1
403 Power monitoring Warning Yes 00 51
404 Brake check Off Yes 00 51
405 Reset mode Manual reset Yes 0 0 5 1
421 Speed PID filter time 1 - 20 ms 3.2 ms Yes 4 -4 6 1
Parameter group 5xx, see serial communication!
NB!:
In parameter 512 it is possible to shift between
crane profile and FC profile!
PNU Parameter Factory setting Changes Unit Conversion Data Protection
#
6xx
description
Service functions
during
operation
index index type level
600 Operation data: Operating hours No 4 74 7 2
601 Operation Data: Running hours No 4 74 7 2
602 Operation Data: kWh counter No 8 2 7 2
603 Operation Data: Power ups No 0 0 6 2
604 Operation Data: Over temps No 0 0 6 2
605 Operation Data: Over volts No 0 0 6 2
615 Fault log: Error code No 0 0 5 2
616 Fault log: Time No 0 -1 7 2
617 Fault log: Value No 0 0 3 2
618 Reset of kWh counter Do not reset Yes 0 0 5 1
619 Reset of hours-run counter Do not reset Yes 0 0 5 1
620 Operating mode Normal function Normal operation Yes 0 0 5 1
621 Type plate: VLT type No 0 0 9 2
622 Type plate: Power section No 0 0 9 2
623 Type plate: VLT ordering number No 0 0 9 2
624 Type plate: Software version
number
No 0 0 9 2
625 Type plate: LCP ID no. No 0 0 9 2
626 Type plate: Parameter database
ID no.
No 0 -2 9 2
627 Type plate: PU database ID no No 0 0 9 2
628 Type plate: Application option
type
No 0 0 9 2
629 Type plate: Application ordering
number
No 0 0 9 2
630 Type plate: Communication type No 0 0 9 2
631 Type plate: Communication
ordering number
No 0 0 9 2
639 Flash test On Yes 0 0 5 1
650 Protection level Yes 0 0 7 2
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.50.N4.02 - VLT is a registered Danfoss trademark
47