1 Resistor connection:
Marked RB1/RB2
Type: Phoenix G10/2
IEC: 0.5-10 mm
2
/800 V
UL: AWG 20–6/600 V
Wire Stripping: 12 mm (0.47 in)
Torque: 1.5-1.8 Nm (13.28-15.94 lb-in)
2 Temperature switch connection
Marked: T1/T2
Type: Phoenix G5/2 with screw connection
IEC: 0.2–4 mm
2
/500 V
UL: AWG 24-12/300 V
Wire Stripping: 8 mm (0.31 in)
Torque: 0.7 Nm (6.2 lb-in)
3 PE: M5
Torque 2–2.7 Nm (17.71-23.91 lb-in)
4 For temperature Switch Cable: Clamping Range: 3.5-7.0
mm (0.14-0.28 lb-in)
5 For resistor cable:
Cable gland with internal connection for braid
Clamping Range: 9.0-16.5 mm (0.35-0.65 lb-in)
Illustration 9.21 Connection Box
Illustration 9.22 IP21, 3D View
Mechanical mounting (see Illustration 9.23):
•
Vertical with connection box down (IP21), or
•
Horizontal (IP20)
Illustration 9.23 Mechanical Mounting
Specifications Design Guide
MG90O202 Danfoss A/S © Rev. 05/2014 All rights reserved. 95
9 9
To Next Page
Loading...
