Complete the following steps to connect the mains cables
for enclosure size H9. Use the tightening torques described
in chapter 3.2.1 Electrical Installation in General.
1. Slide the mounting plate into place and tighten
the 2 screws as shown in Illustration 3.8.
-DC+DC
BR- BR+ U V W
99
M A I N S
95
RELAY 1 RELAY 2
- LC +
130BA261.10
Illustration 3.8 Mounting the Mounting Plate
2. Mount the ground cable as shown in
Illustration 3.9.
130BA262.10
M
I N S
+DC
BR-
BR+
U
V
W
RELAY 1 RELAY 2
95
Illustration 3.9 Mounting the Ground Cable
3. Insert the mains cables to the mains plug and
tighten the screws as shown in Illustration 3.10.
130BA263.10
95
M
A
INS
+DC
BR-
BR+
U
V
W
91
92
93
L1
L2
L3
RELAY 1 RELAY 2
Illustration 3.10 Mounting the Mains Plug
Installation Quick Guide
MG18A802 Danfoss A/S © 05/2016 All rights reserved. 13
3 3
To Next Page
Loading...
