Danfoss VLT FC Series Installation Guide

Voltage [V] Minimum waiting time (minutes)
525–690 – 1.5–7.5 kW
(2–10 hp)
11–75 kW
(15–100 hp)
37–315 kW
(50–450 hp)
355–1200 kW
(450–1550 hp)
355–2000 kW
(450–2050 hp)
355–710 kW
(400–950 hp)
690 – – – 55–315 kW
(75–400 hp)
– –
Table 5: Discharge Time, VLT® Lift Drive LD 302
Voltage [V] Minimum waiting time (minutes)
4 15
380–480 0.25–7.5 kW
(0.34–10 hp)
11–75 kW
(15–100 hp)
1.3 Items Supplied
The following is supplied:
• Control card.
1.4 Tools
Only 2 tools are required for replacing the control card:
• Torx 10 screwdriver.
• Flat-head screwdriver.
1.5 More Items Required
• An FC Series drive.
Introduction
Installation Guide | Control Card VLT® FC Series
AN279051429263en-000101 / 130R0788
4 | Danfoss A/S © 2018.09

Danfoss VLT FC Series Specifications

General

Category	DC Drives
Series	VLT FC Series
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Overtemperature, Motor overload
Communication Interfaces	CANopen, PROFIBUS, Ethernet
Cooling Method	liquid-cooled
Enclosure Rating	IP20, IP21, IP55
Ambient Temperature	-10°C to +40°C (14°F to 104°F) without derating