Intermittent (3x380–440 V) [A]
Continuous (3x441–480 V) [A]
Intermittent (3x441–480 V) [A]
1
Applies for dimensioning of drive cooling. If the switching frequency is higher than the default setting, the power losses may increase. LCP and
typical control card power consumptions are included. For power loss data according to EN 50598-2, refer to Danfoss MyDrive® ecoSmart website.
2
Efficiency measured at nominal current. For energy efficiency class, see 6.4.13 Ambient Conditions. For part load losses, see Danfoss MyDrive®
ecoSmart website.
6.2 EMC Emission Test Results
The following test results have been obtained using a system with a drive, a shielded control cable, a control box with potentiome-
ter, and a shielded motor cable.
Table 18: EMC Emission Test Results
Conduct emission. Maximum shielded cable length [m (ft)]
Class A Group 2
Industrial environ-
ment
Class A Group 1
Industrial environ-
ment
Class B
Housing, trades and
light industries
Class A Group 1
Industrial environ-
ment
Class B
Housing, trades
and light industries
Category C3
Second environment
Industrial
Category C2
First environment
Home and office
Category C1
First environment
Home and office
Category C2
First environment
Home and office
Category C1
First environment
Home and office
H2 RFI filter (EN 55011 A2, EN/IEC 61800-3 C3)
0.75–18.5
kW (1.0–25
hp) 3x380–
480 V IP54
22–90 kW
(30–120 hp)
3x380–480
V IP54
H3 RFI filter (EN55011 A1/B, EN/IEC 61800-3 C2/C1)
0.75–18.5
kW (1.0–25
hp) 3x380–
480 V IP54
22–90 kW
(30–120 hp)
3x380–480
V IP54
AQ367426199594en-000101 / 130R0988 | 47Danfoss A/S © 2021.06
Specifications
VLT® HVAC Drive FC 131
Operating Guide