3.2.7 0-5* Copy / Save
Copy parameter settings between set-ups and to/from the LCP.
0-50 LCP Copy
Option: Function:
[0] * No copy No function
[1] All to LCP Copies all parameters in all set-ups from the adjustable frequency drive memory to the LCP memory.
For service purposes, it is recommended to copy all parameters to the LCP after commissioning.
[2] All from LCP Copies all parameters in all set-ups from the LCP memory to the adjustable frequency drive memory.
[3] Size indep. of LCP Copies only the parameters that are independent of the motor size. The latter selection can be used
to program several adjustable frequency drives with the same function without disturbing motor
data which are already set.
This parameter cannot be adjusted while the motor is running.
0-51 Set-up Copy
Option: Function:
[0] * No copy No function
[1] Copy to set-up 1 Copies all parameters in the present Programming Set-up (defined in par.0-11
Programming Set-
up
) to Set-up 1.
[2] Copy to set-up 2 Copies all parameters in the present Programming Set-up (defined in par.0-11
Programming Set-
up
) to Set-up 2.
[3] Copy to set-up 3 Copies all parameters in the present Programming Set-up (defined in par.0-11
Programming Set-
up
) to Set-up 3.
[4] Copy to set-up 4 Copies all parameters in the present Programming Set-up (defined in par.0-11
Programming Set-
up
) to Set-up 4.
[9] Copy to all Copies the parameters in the present set-up over to each of the Set-ups 1 to 4.
3.2.8 0-6* Password
Define password access to menus.
0-60 Main Menu Password
Range: Function:
100 N/A* [0 - 999 N/A] Define the password for access to the main menu via the [Main Menu] key. If par.0-61
Access to
Main Menu w/o Password
is set to
Full access
[0], this parameter will be ignored.
0-61 Access to Main Menu w/o Password
Option: Function:
[0] * Full access Disables password defined in par.0-60
Main Menu Password
.
[1] Read-only Prevent unauthorized editing of main menu parameters.
[2] No access Prevent unauthorized viewing and editing of main menu parameters.
[16] All: No access
If
Full access
[0] is selected then par.0-60
Main Menu Password
, par.0-65
Personal Menu Password
and par.0-66
Access to Personal Menu w/o Pass-
word
will be ignored.
VLT
®
HVAC Drive Programming Guide 3 Parameter Description
MG.11.C6.22 - VLT
®
is a registered Danfoss trademark
3-15
3