Danfoss VLT HVAC - Page 65

Function:
Select a variable for display in line 2. The op-
tions are the same as those listed for par. 0-20
Display Line 1.1 Small .
0-24 Display Line 3 Large
Value:
Counter [kWh] [1502]
Function:
Select a variable for display in line 2. The op-
tions are the same as those listed for par. 0-20
Display Line 1.1 Small .
0-37 Display Text 1
Function:
In this parameter it is possible to write an in-
dividual text string for display in the LCP or to
be read via serial communication. If to be dis-
played permanently select Display Text 1 in
par. 0-20, 0-21, 0-22, 0-23 or 0-24,
Display
Line XXX
. Use the ▴ or ▾ buttons on the LCP
to change a character. Use the ◂ and ▸ but-
tons to move the cursor. Then a character is
highlighted by a cursor, this character can be
changed. A character can be inserted by plac-
ing the cursor between two characters and
pressing ▴ for ▾.
0-38 Display Text 2
Function:
In this parameter it is possible to write an in-
dividual text string for display in the LCP or to
be read via serial communication. If to be dis-
played permanently select Display Text 2 in
par. 0-20, 0-21, 0-22, 0-23 or 0-24,
Display
Line XXX
. Use the ▴ or ▾ buttons on the LCP
to change a character. Use the ◂ and ▸ but-
tons to move the cursor. Then a character is
highlighted by a cursor, this character can be
changed. A character can be inserted by plac-
ing the cursor between two characters and
pressing ▴ for ▾.
0-39 Display Text 3
Function:
In this parameter it is possible to write an in-
dividual text string for display in the LCP or to
be read via serial communication. If to be dis-
played permanently select Display Text 3 in
par. 0-20, 0-21, 0-22, 0-23 or 0-24,
Display
Line XXX
. Use the ▴ or ▾ buttons on the LCP
to change a character. Use the ◂ and ▸ but-
tons to move the cursor. Then a character is
highlighted by a cursor, this character can be
changed. A character can be inserted by plac-
ing the cursor between two characters and
pressing ▴ for ▾.
0-70 Set Date and Time
Value:
2000-01-01 00:00 –
2099-12-01 23:59
2000-01-01
00:00
Function:
Sets the date and time of the internal clock.
The format to be used is set in par. 0-71 and
0-72.
NB!
This parameter does not display
the actual time. This can be read
in par. 0-89. The clock will not
begin counting until a setting
different from default has been
made.
0-71 Date Format
Value:
YYYY-MM-DD [0]
DD-MM-YYYY [1]
MM/DD/YYYY [2]
Function:
Sets the date format to be used in the LCP.
0-72 Time Format
Value:
24 H [*0]
12 H [1]
VLT
®
HVAC Drive Operating Instructions 6. How to programme the frequency converter
MG.11.A4.02 - 09.10.06. VLT
®
is a registered Danfoss trademark 65
6