3.2 | Water outlet
Plug the water drain hose to the back of Bob.
Warning: To prevent leaks, please use the provided
clamp to fix the water outlet.
Connect the water outlet hose to a siphon
drain pipe (usually accessible under the sink)
Warning: The waste water coming out of Bob can
reach high temperature of up to 70°C.
1
Siphon drain pipe
Tighten the clamp screw with the supplied Bob
screwdriver/bottle opener and use the key ring to
tighten the screw! Then attach it to your key ring.
Pretty handy, as it will from now on follow you
everywhere as a bottle opener or screwdriver.
2
Place the drain hose directly in your sink and fix it with the equipment
provided by Daan Tech.
Place the drain hose in a container (jerrican, bucket, etc...)
To avoid possible flooding, the container shall have a capacity of at least 4L.
Fixed installation
Flexible installation
If you have found a new way to fix Bob’s water outlet please
send us a picture.
Install the water outlet drain hose either in a fixed or flexible mode by using the
equipment provided by Daan Tech.
Warning: Do not block the water inlet of
the water tank. This must always remain
free.
2 options for evacutaing the waste water
7
QUICK SET-UP GUIDE
6
QUICK SET-UP GUIDE
To Next Page
Loading...