Dantherm ACT-7 - Menu Overview and Settings

15
Operation: User interactions
Main menu Submenu
Temperature
• Set the start temperature for
the air conditioner (5-30°C).
The value is set to 15°C by
default.
(NONE)
Reset alarm
(use only, when alarm is visible
on display and the underlying
problem has been solved)
• When an alarm (H or L) is
shown on the display and
the error has been rectied,
the alarm has to be reset in
the submenu (HP fault/ LP
fault) in order to start the
unit up again.
HP fault
• See trouble shooting on page 17.
LP fault
• See trouble shooting on page 17.
Advanced
• Access the submenus
Oset
• An oset(+/- 0-99) is used to calibrate the
temperature shown on the main screen.
• This feature can be used, when e.g. ducting
is connected and the temperature of the
ventilated place is dierent from the tem-
perature displayed.
Enable pin
• The pin code (1234) is disabled by default.
When the pin is enabled, you have to type
the pin code before you can change the
settings.
- 1 = Enabling pin
- 0 = disabling pin
Language
• The language is set to English by default.
Change the language of the menu:
- English
- Francais
- Deutsche
Menu overview
en