Dantherm HRC 2 User Manual

16
Installer menu / installer mode
Introduction
The installer menu is dedicated to skilled/experienced installers and service technicians
who have a thorough knowledge of ventilation plants.
The purpose of the INSTALLER
MENU/MODE is to put the unit in a state where the in-
staller can adjust the nominal air volume (fan step 3), without other functions or te
m-
peratures of the unit preventing it. I.e. as long as the unit is in INSTALLER MODE fan
step 3 is maintained.
Warning:
Dantherm Air Handling A/S disclaims any responsibility if the unit is installed in a way
that has a negative influence either on the heat consumption in the house, or the indoor
climate or if the unit is installed in such a way that the building, the buil
ding structure
and the furniture are damaged.
Start Installer
menu/mode
Press RIGHT for 10 sec. to activate the installer menu, until the ventilation unit icon on
the display is flashing slowly. The installer menu can also be activated by pressing
MANUAL and AUTO on the unit’s control panel for 10 sec.
The installer menu will
be active for 60 minutes or until the same button is pressed
again.
Installer menu
Following menus and operating information are available in the installer menu:
il

Dantherm HRC 2 Specifications

General

Brand	Dantherm
Model	HRC 2
Category	Remote Control
Language	English