065379 • Version 1.1 • 06.03.2013
The remote control has to be paired with the ventilation unit before use. Follow the pro-
cedure below to
pair the wireless remote control with the ventilation unit: (communica-
tion is between the control panel (HCP4) and the remote control (HRC2))
Disconnect the power to the ventilation unit
2 Open the battery lid on the remote control and insert the batteries (2 x AAA)
which are included with the remote control.
3 If you want a fixed power supply you can connect a mini-USB cable with pow-
er supply (accessory). The mini USB-plug is situated behind the battery door
on the back of the remote control.
4 Reconnect the power to the unit. The unit and the remote control now try to
connect with each other for the next 60 seconds and when connection is
made, data from the unit are shown on the display.
If pairing is not successful the first time (
display shows E13), this maybe because the
distance between the remote control and the unit control panel (HCP4) is too big, or the
remote control has already been paired with another ventilation unit. In that case, reset
the remote control by pressing dow
n the LEFT part of the navigation key for 10 sec.,
until all icons are flashing. Then a new pairing can start.
It is possible to connect up to 5 remote controls to one ventilation unit. All
remote controls are equal. This means that the latest change of operation or setpoints
overrules the previous change, if any.
To Next Page
Loading...
Need help?
General
