DanVex DD Series - Operational Safety Cautions

Page 23 of 39
Setting (Commands of the master controller to the dehumidifier controller):
0x01
Machine Condition
1: Indicate in operation
2: Start
0: Off
0x02
Fan Speed 1-3
3 level fan speed
0x03
Read Current
Humidity Level (%)
Note: The remote
temperature and
humidity will not work
until it is turned on.
0x04
Read Current
Temperature (°C)
Note: The remote
temperature and
humidity will not work
until it is turned on.
0x05
Humidity setting
value (%)
0x09
Remote
temperature and
humidity
1: Use Remote
Temperature and
Humidity
0: Use local
Temperature and
humidity
0x0A
Turn on
dehumidification /
humidification
2: turn on
humidification
1:
turn on
dehumidification
0: close (turn off
compressor,
humidifier)
0x0B
Turn on Air Mixing
Function
1: Turn on Mixed Air
valve
0: turn on Internal
Circulation (Valve
Control)
4.3 Safety Cautions
Dehumidifier has high-speed moving parts. Before running, make sure panel is closed correctly and
no debris present at the exterior. Do not uses force to open the machine during operation
otherwise; it will cause serious consequences to dehumidifier.
A. Temperature and humidity sensors are sensitive components, do not touch the components;
B. All wires are distinguished by colors, please let professionals do the wiring work;
C. Temperature and humidity control should be placed in clean environment. Acetone, chlorine
or high concentrations smoke and will cause damage;
D. Humidistat is sensitive to ambient humidity. Do not place in dusty area.
E. If some problem happened to the dehumidifier, it will stop. Please check the machine first
before turn in on again.
F. Don’t move dehumidifier or unplug until the fan stops;