EasyManuals Logo

Data Aire gForce GT series User Manual

Default Icon
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33
Data Aire, Inc.
Quarterly Maintenance Inspection Checklist
Model No. _______________________ Serial No. ___________________________
Prepared by: _____________________ Date: ___ / ___/ 201__
Air Filters
____ Checkforrestrictedairow
____ Checklterdifferentialswitch
____ Wipelterracksectionclean
Air Distribution Section
____ Check for restriction in grille(s)
Compressor
____ Check for leaks
Refrigeration Cycle/Section
____ Check for moisture (site glass)
____ Check suction pressure
____ Check discharge pressure
____ Check hot gas bypass valve operation
____ Check thermostatic expansion valve operation
____ Check solenoid valve operation
Air Cooled Condenser (if applicable)
____ Condenser coil clean
____ Motor mounts tight
____ Motor fan bearings in good condition
____ Refrigeration lines properly supported
____ Heated receiver site glass #1 __ #2 __
Water/Glycol Fluid Cooler (if applicable)
____ Water regulating valve function
____ Check solution _____%
____ Check for water/glycol leaks (piping area)
____ Water/Glycolowswitchoperational
Glycol Pump(s)
____ Glycol leaks (pump area)
____ Pump operation
____ Auto air vent clean of mineral deposits
Condensate Drain and Pump (if applicable)
____ Checkforwaterleaksandrestrictedow
____ Pump operation
Steam Generating Humidier
____ Check canister for deposits and water level
____ Check condition of steam hose and clamps
____ Checkdrainandllvalvefordeposits
Reheat
____ Check reheat element(s) for dust
____ Check high limit switch operation
Electrical Panel
____ Check fuses
____ Check contactor operation
____ Check all electrical connections
____ Check operation sequence
____ Check calibration of change over thermostat
(Energy Saver System Only)
dap4 control panel operations
____ Check calibration of temperature sensor
____ Check calibration of humidity sensor
____ Check calibration of discharge air sensor
Equipment Runtimes
Condenser ____________ hrs
Compressor ____________ hrs
Reheat No. 1 ____________ hrs
Reheat No. 2 ____________ hrs
Reheat No. 3 ____________ hrs
Humidier ____________ hrs
Dehumidication ____________ hrs
Energy Saver ____________ hrs
____Reset all to read zero runtimes
Temperature/Humidity set at: _____° _____% RH

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Data Aire gForce GT series and is the answer not in the manual?

Data Aire gForce GT series Specifications

General IconGeneral
BrandData Aire
ModelgForce GT series
CategoryAir Conditioner
LanguageEnglish

Related product manuals