Data Aire idap - Configure idap Card on Start-up; Program IP Address via Display Panel

7
thecardusingnewIPaddress.Repeatsteps4to12toconnecttothecardandverifytheIP
address if you cannot connect to the card, use a new IP address. Ping the idap card IP ad-
dress to verify the connection.
C. Program IP Address on idap Card Using dap4 Display Panel Keypad
Note: This procedure applies to dap4 controller with BIOS version 5.18 or later and idap card
withrmwareversionA1.5.0B1.2.4orlater.dap4BIOSversionnumbercanbeviewedon
dap4 menu F - Information.
1.ToprogramtheIPaddresstotheidapcardusingthedap4displaykeypad,simplypressand
holdtheALARMandENTERkeyssimultaneouslyforonesecond,thefollowingscreenwill
appear:
>SYSTEMINFORMATION
LOG DATA
OTHERINFORMATION
FLASH/USBMEMORY
2. UseSelectdownkey(i)tomovethecursortoOTHERINFORMATIONandpressEnter.
This screen will appear:
>IDNUMBERINFO
PCOWEB/NETCONFIG
MEMORIESSTATUS
3. UseSelectdownkey(i)thenEnterkeytoselectPCOWEB/NETCONFIG,thefollowing
screen will appear:
>PCOWEB settings
PCONETsettings
4. PressEnterkeytoselectPCOWEBsettingsoption.Thefollowingscreenwillappear:
DHCP:ON
IPAddress:
---.---.---.---
5. UseEnterkeytomovethecursorthenusethearrowkeystomakechange.Ifyouselect
DHCPON,youcannotenterastaticIPaddress.SelectOFFonDHCPifyouwanttoentera
static address.
6. PressSelectdownkey(i)togotonextpagetoenterNetMaskandGatewayaddressthen
gotothenextpagetoenterDNS1andDNS2addressifnot,pressSelectdown(i)keytogo
to next page.
7. You may enter a BACnet device instance number if BACnet connection required otherwise
pressSelectdownkey(i)togotothenextpage,thescreenwillappear:
PCONETCONFIGENABLE
UpdatepCOweb?NO
8. UseSelectdownkey(i)toselectYESthenpressEnterkeytoconrmthechange.
These screens will show:
PCOwebCONFIGENABLE
Please wait for end of update
Then
PCOwebCONFIGENABLE
Updatecomplete-RebootpCOnettoapplynewsettings