Data Aire Mini dap4 - Page 12

12 • Mini dap4 User Manual
Enter Menu C by pressing the ENTER key. The following message will be displayed (values are for reference only):
To change the date or time, move the cursor by pressing the ENTER key to the date. To change the date, use the UP
or DOWN keys. By pressing the ENTER key the cursor will move from segment to segment. Only the UP and DOWN
keys will change the value. The day will automatically change when the date has been altered.
Press the ENTER key until the cursor is in the title block (upper left hand corner). Press the UP or DOWN key to see
the next screen.
The following will be displayed (values are for reference only):
Note: Leaving the “Set-Back Enable” as NO, the set-back feature is non-operational and is the recommended
setting for applications with constant load and cooling requirements.
The factory setting is NO
Ranges:
Override Time - the range is 1-12 hours
Cooling Offset - the range is 0-30°F
Heating Offset - the range is 0-30°F
Humidify Offset - the range is 0-30%
Dehumidify Offset - the range is 0-30%
If Set-Back enable is YES, the Override Schedule will appear as the following (values are for reference only):
To change values, move the cursor to the desired input by pressing the ENTER key. Change the value by pressing
either the UP or DOWN key. Once all changes are made to inputs on screen, move the cursor to the top and press
the UP or DOWN keys to move to the next screen or press the MENU key to return to Main Menu screen.
Clock Settings
Day: Saturday
Date: 05/16/11
Hour 09:39
Set-Back Setting
Set-Back Enable: No
Override Time: 12Hrs
Cooling Offset 5.0
o
F
Humidity Offset: 10%
Dehumidify Offset: 10%
Set-Back Setting
Set-Back Enable: Yes
Override Schedule No
Override Time: 12Hrs
Cooling Offset 5.0
o
F
Humidity Offset: 10%
Dehumidify Offset: 10%