2 CE870 Instant Issuance System
CE870 Instant Issuance System Quick Install Guide
1. Select a Location for the Printer
• Install the printer in a location that is clean and well
ventilated, free of vibration or shock.
• For venting and clearance, choose an area that has the
following measurements:
• Single-Hopper System: 27 inches (686 mm) wide,
31 inches (788 mm) deep, and at least 27.4 inches
(696 mm) high.
• Multi-Hopper System: 28 inches (711 mm) wide,
41 inches (1041 mm) deep, and at least 30 inches
(762 mm) high.
Refer to the printer’s Installation and Administrator’s
Guide for complete site requirements.
• Do not install the printer in direct sunlight.
• Install the system in a secure location.
• Install the system in a location that has access to two
AC outlets and a network port.
Refer to your printer’s Installation and Administrator’s Guide,
found on the Owner’s Library CD, for detailed installation
instructions.
To Next Page
