Page 27
Site requirements
Operating environment
• Relative humidity: 20% to 80% non-condensing
• Temperature: 60° F to 95° F (15° C to 35° C)
Electrical requirements
• The external power supply is rated at 100-240 VAC, 50-60
Hz, 1.8 amp. (It adjusts to any power within this range.)
• Single phase, 3-wire, grounded receptacle only.
Physical requirements
• The printer weighs less than 9 pounds (4kg). The weight
depends on the supplies and options installed.
• Printer dimensions are 16.5 inches (419 mm) long, and 7.8
inches (198 mm) wide. The printer is 9 inches (229 mm) high.
• The clearances required are 1 inch (25mm) at the back, 2
inches (51 mm) on the left side, and 10.5 inches (267 mm)
above the printer latch to open the cover.
• Do not use the printer in a dirty environment. Do not use the
printer in a closed compartment. Do not block air flow around
the printer.
To Next Page
Loading...
